65W full protocol mobile phone fast charge charger module support Huawei OPPO Apple fast charging motherboard PD/qc4.0

9V-35V input

Default DC5521 input interface

Optional XT30 Input port

Large current USB output interface

Maximum 65W output power

Short -circuit protection

Up to 93%conversion efficiency

-40 ° CTO+85 ° C

Support BC1.2 charging protocol

Support Apple 5V24A

Support PD2.0/3.0/PPS

Support OC2.0/3.0/4.0, etc.

Support FCP, SCP, HSCP

VOOC/DASH/Warp

Support superVooc2.0

Support multiple direct rush protocols

The thickness of the board is 11.5mm, and the four snail aperture is 2.0mm module input interface.

DC5521 interface Input: Enter DC 9V-35V, internal and external.Label+: Optional welding input positive electrode, or the XT30 interface positive electrode.Label-: Optional welding input negative electrode, or the XT30 interface negative electrode

Precautions

The product input should be greater than the output voltage.

If you need to weld, it is best to disconnect the power when the wiring. There will be a certain risk to hit the chip with electric welding and penetrate the chip

The wiring cannot be too detailed, ensuring that the wire can withstand the corresponding current

Many fast charge requirements are required to use the original line, otherwise it will cause fast charging, or slow charging

The larger the module, the closer the current is to the maximum current.The greater the fever, pay attention to heat dissipation when using.

*The actual charging power of the mobile phone is related to the mobile phone protocol, and it is related to the life of the mobile phone battery. Based on the actual, the maximum voltage of the module output is 12V, the maximum current is 4A, the charging power and voltage are also very related.In the same way, this is determined by the mobile phone, the module is determined by the right, and the module is passively responding to the phone charging instruction.A small number of mobile phones are not open to third -party fast charge. After the mobile phone is upgraded, it may block third -party fast charging. It is normal.

If the mobile phone is a direct rush protocol, when the mobile phone power is low, the high power direct rush is started. When the power is reached, the current will decrease as the power increases. It is a normal phenomenon.If the power of the mobile phone is detected, this is controlled by the mobile phone with the charging management chip, which mainly guarantees the safety and extend the battery life