Golden SW-520D angle sensor module Rolling switch vibration switch tilt sensor module

use:

All kinds of products are tilted, dumping to trigger alarm, dumping the power -off sensor, and the tilt sensor.

Module characteristics:
1. Use a high-sensitivity angle switch SW-520D as a sensor.
2. The output of the comparator, the signal is clean, the waveform is good, and the driver capacity is strong, more than 15mA.
3. Work voltage 3.3V-5V
4. Output form: Digital switching output (0 and 1)
5. There are fixed bolt holes for easy installation
6. Small board PCB size: 3.2cm x 1.4cm
7. Use width voltage LM393 comparator
Module use instructions
1. Please look at the wiring of this module.
2. The switch volume of the module output depends on the turnover and disconnection of the angle switch. When the angle switch is broken, the DO output is high level, and when the angle switch is turned on, the DO output is low;
3. The output terminal can be directly connected to the single -chip microcomputer, and the high and low level can be detected by a single chip machine.
4. The output terminal can directly drive the relay module, which can form a high -power angle switch to protect the function of automatic power off when the electrical equipment and other products are dumped.