MCU-20948 ICM-201948 Low-power 9-axis MEMS Movement Tracking Device Sensor

CJMCU-20948 ICM-20948 Low-power 9-axis MEMS Movement Device Sensor

feature
• 9 -axis equipment with the lowest power consumption, with a power consumption of 2.5 mW
• Three gyroscopes with programmable FSR
± 250 dps, ± 500 dps, ± 1000 dps and ± 2000 DPS
• 3 axis plus speed meter with a programmable FSR
± 2g, ± 4g, ± 8g and ± 16g
• 3 axis compass, the range is ± 4900 μT
• Endless digital motion processor (DMP)
• Android support
• Auxiliary I2C interface of external sensors
• 16 -bit ADC and programmable filter on the film
• 7 MHz SPI or 400 kHz fast mode I²C
• Digital output temperature sensor
• VDD working range is 1.71V to 3.6V
• The sealing MEMS structure
Wafer
There are up to 4 two -way DC motors with a single 8 -bit speed selection (therefore, about 0.5 % resolution)
A maximum of 2 has a single coil, a double coil, a step -by -step motor (single or bipolar).
The motor is automatically disabled when calling
Large wiring terminal connectors can easily connect the wires (18-26AWG) and power supply
RDUINO reset button pops up the top
Two needle -end blocks and cross -connecting lines with polar protection are used to connect external power supply and for separate logic/motor power supply

With assembly and test shielding layers, terminal blocks, ordinary plugs, jump lines.Some welding is needed to assemble the joints.It does not include stacking joints, but we sell them in the store, so if you want to stack the shield, please pick them up at the same time.It does not include RDUINO and motor.However, we have a lot of motors in the store and all of our amateur servers. The DC motor and step -by -step motor are easy to use.