MCU FT232H High -speed Multifunctional USB to JTAG UART/FIFO SPI/I2C module

MCU FT232H high -speed multi -function USB to JTAG UART/FIFO IIC I2C module external memory

Typical Applications
? Single Chip usb to urt (RS232, RS422 or RS485)
? USB to FIFO
? USB to FT1248
? USB to jtag
? USB to SPI
? USB to I2C
? USB to Bit-Bang
? USB to Fast Serial Interface
? USB to CPU TARGET Interface (As Memory)
CJMCU-FT232H is a Single Channel USB 2.0 Hi-Speed ​​(480MB/S) to UART/FIFO IC. It has the capability of being configured in a variety of Industry. or Parallel Interfaces. The FT232H Has the Follow Advanced Features:
? Single Channel usb to service / Ports with a variety of configurations.
? Entire usb protocol handled on the chip. No usb spiecific firmware programming required.
? USB 2.0 Hi-Speed ​​(480MBits/Second) and Full Speed ​​(12mbits/Second) compatible.
? Multi-ProTocol Synchronous Serial Engine (MPSSE) to Simplify Synchronous Serial Protocol (USB to JTAG, I2C, SPI (Master) or BIT-BANG) Design.
? UART Transfer Data Rate up to 12Mbaud. (RS232 Data Rate Limited by External Level Shifter).
? USB to Asynchronous 245 FIFO MODE for Transfer Data Rate up to 8 MBYTE/SEC.
? USB to Synchronous 245 Parallel Fifo Mode for Transfers Upto 40 MBYTES/SEC
? SUPPORTS A Progression Half Duplex FT1248 Interface with A Configurable Width, BI-Directional Data Bus (1, 2, 4 or 8 Bits Wide).
? CPU-Style Fifo Interface Mode Simplifies CPU Interface Design.
? Fast Serial Interface Option.
? FTDI ’s RoyalTy-Free Virtual Com port (VCP) and Direct (D2XX) Drivers Eliminate the Requirement for USB Driver Development in Most Cases.
? Adjustable Receive buffer timeout.